

We stock three fork slider collars:
We modify the stock collars to make them easier to install and remove. You normally need to use a pipe wrench to remove and
install the stock collar, which tends to damage the outside of the collar.
Our modified collars can be installed or removed with a large crecent wrench.
The collar is always covered up by a boot or gaiter, so the damage caused by a pipe wrench is not seen,
but you have damaged a good part, and if not careful, you could also damage the aluminum slider.


Norton Parts . Frame, Front Forks
This page was written and designed by F. H. Eaton
& Associates if you have any questions or comments please
contact us at infon@fheaton.com